| 工业地坪验收标准 |
| 添加时间：2019/9/12 13:47:27 浏览次数： |
| 工业地坪验收标准 Acceptance Standard for Industrial Floor 1、环境温度为25℃时，施工后2-3天应达到实干，即硬度达到完成固化的80%左右; 1. When the ambient temperature is 25 C, the hardness should reach about 80% of the solidification after 2-3 days of construction. 2、表面不能出现发粘现象; 2. No sticking on the surface. 3、气泡:平涂型、砂浆型无气泡，自流平允许1个小气泡/10平方米; 3. Bubbles: flat coating and mortar without bubbles, self-leveling allows one small bubbles per 10 square meters; 4、流平性好，无镘刀痕，大面积接口处基本平整; 4. It has good leveling, no trowel mark and smooth interface in large area. 5、无浮色发花，颜色均匀一致，大面积接口处允许有极不明显的色差; 5. No float, uniform and uniform colors, allowed to have very little obvious color difference at large areas of the interface; 6、无粗杂质，但允许有空气中的浮尘掉落在造成的极小缺陷; 6. There are no coarse impurities, but the dust in the air is allowed to fall on the minimal defects. 7、地坪表面应平整平滑，光泽度应达到设计要求(高光泽≥90、有光≥70、半光50~70)，平涂型为有光、水性为半光~无光; 7. The surface of the floor should be smooth and smooth, and the glossiness should meet the design requirements (high gloss (> 90), gloss (> 70), half gloss (> 50 ~ 70), and the flat coating type should be glossy and water-based should be half glossy (~dull). 8、桔皮、砂浆防滑面效果应很明显。 8. The anti-skid effect of orange peel and mortar should be obvious. |
| 上一页 耐磨地坪应用 |
| 下一页 环氧防静电地坪施工基面要求 |