| 耐磨地坪注意事项 |
| 添加时间：2019/6/25 14:13:03 浏览次数： |
| 耐磨地坪注意事项 Attentions to Wear Resistant Floor ①由于耐磨材料施工与水泥地坪浇筑几乎是同时进行，为保证耐磨层施工质量和施工进度，混浇筑应作好配合; Because the construction of wear-resisting material and the pouring of cement floor are almost carried out at the same time, in order to ensure the construction quality and construction progress of wear-resisting layer, the mixing pouring should be well coordinated. ②模板设置应平整坚固，模板以6米为宜，并涂脱模油，用水平仪随时检测模板标高，对偏差处应及时调整; (2) Template setting should be smooth and firm, 6 meters is suitable for template, and stripping oil is applied. Template elevation should be detected at any time by level instrument, and deviation should be adjusted in time. ③混凝土强度不低于C25，且尽可能小的水灰比; (3) Concrete strength is not less than C25, and the water cement ratio is as small as possible; ④使用插入式振捣棒和平板式振捣器作业，振捣后使用水平仪检测模板水平情况，对偏差部位进行调整; (4) Inserted vibrating rod and plate vibrator are used to work. After vibrating, the level of the template is detected by a level meter, and the deviation position is adjusted. ⑤使用较重的钢制长辊(钢辊应宽于模板)多次反复压，并保持钢模洁净，使地坪平整，无法使用钢辊作业部位，应用刮尺整平; _Using heavy steel long rolls (steel rolls should be wider than formwork) repeated pressing, and keep www.xindejinwei.com www.bdkaixiang.cn www.zhongguodingli.com www.prtqd.com www.hebship.com www.ewinby.com the steel mold clean, so that the floor is flat, can not use the steel roll working parts, the application of scraper leveling; ⑥对泌水严重部位，应用橡胶管去泌水; _Rubber tube should be used to remove bleeding in serious parts of bleeding. ⑦卸模最好等耐磨面层完成第二天进行，第三天由建筑方切伸缩缝; _The best way to unload the die is to wait for the wear-resistant surface to be finished the next day, and the third day is to cut the expansion joint by the building square. ⑧在乙方施工期内，不安排交叉施工，并应负责对方已施工好的地坪进行保护与养护，甲方应提供水电。 During the construction period of Party B, there is no arrangement for cross-construction, and Party A shall be responsible for the protection and maintenance of the other party's already constructed floors. Party A shall provide hydropower. |
| 上一页 耐磨地坪施工步骤 |
| 下一页 耐磨地坪施工步骤 |