联系我们
名称：彩色透水地坪品牌厂
电话：xxx
手机：xxx
邮箱：xxx
地址：xxx
新闻动态
防静电活动地板的防火等级
1、防静电活动地板的防火等级，应符合《建筑内部装修设计防火规范》的要求。
1. The fire rating of anti-static raised floor shall meet the requirements of code for fire protection design of interior decoration of buildings.
2、防静电活动地板的高度应根据使用要求而定。
2. The height of anti-static raised floor shall be determined according to the use requirements.
(1)仅供走线用:基本尺寸为250mm。
(1) for wiring only: the basic size is 250mm.
(2)供走线及空调风库用:基本尺寸为500mm。地板的可卸板能互换，并有较高的制作精度，以保证地板空间作为空调风库使用时所需的密封性。
(2) for wiring and air conditioning wind house: the basic size is 500mm. The detachable boards of the floor can be interchanged and have high manufacturing accuracy, so as to ensure the tightness of the floor space when it is used as the air-conditioning wind house.
3、防静电机房活动地板铺装施工是建筑装修的最后阶段。应在室内吊顶板铺设完成,顶棚的灯具、通风口也安装完成之后，清理干净地面，铺装活动地板(有保温棉和线槽的要先铺好保温棉和线槽)。
3. The construction of anti-static machine room raised floor pavement is the final stage of building decoration. After the indoor ceiling board is laid and the ceiling lamps and vents are installed, the floor shall be cleaned and the raised floor shall be paved (if there are insulation cotton and trunking, the insulation cotton and trunking shall be paved first).
4、防静电机房活动地板铺设在已找平的水泥砂浆垫层上，为了降低地面做法的高度，直接铺在结构楼板上时，结构楼板要求表面平整，并喷涂界面剂，固化混凝土表面，使地面不起砂。
4. The raised floor of the anti-static machine room is laid on the leveled cement mortar cushion. In order to reduce the height of the ground, when it is directly laid on the structural floor slab, the surface of the structural floor slab is required to be flat, and the interface agent is sprayed to solidify the concrete surface, so that the ground cannot be sanded.
5、地板表面应柔光、不打滑、耐磨、耐污染。
5. The floor surface shall be soft, smooth, wear-resistant and pollution resistant.
6、地板安装完后一定要进行接地处理，否则起不到防静电作用。
6. The floor must be grounded after installation, otherwise it will not play an anti-static role.
1. The fire rating of anti-static raised floor shall meet the requirements of code for fire protection design of interior decoration of buildings.
2、防静电活动地板的高度应根据使用要求而定。
2. The height of anti-static raised floor shall be determined according to the use requirements.
(1)仅供走线用:基本尺寸为250mm。
(1) for wiring only: the basic size is 250mm.
(2)供走线及空调风库用:基本尺寸为500mm。地板的可卸板能互换，并有较高的制作精度，以保证地板空间作为空调风库使用时所需的密封性。
(2) for wiring and air conditioning wind house: the basic size is 500mm. The detachable boards of the floor can be interchanged and have high manufacturing accuracy, so as to ensure the tightness of the floor space when it is used as the air-conditioning wind house.
3、防静电机房活动地板铺装施工是建筑装修的最后阶段。应在室内吊顶板铺设完成,顶棚的灯具、通风口也安装完成之后，清理干净地面，铺装活动地板(有保温棉和线槽的要先铺好保温棉和线槽)。
3. The construction of anti-static machine room raised floor pavement is the final stage of building decoration. After the indoor ceiling board is laid and the ceiling lamps and vents are installed, the floor shall be cleaned and the raised floor shall be paved (if there are insulation cotton and trunking, the insulation cotton and trunking shall be paved first).
4、防静电机房活动地板铺设在已找平的水泥砂浆垫层上，为了降低地面做法的高度，直接铺在结构楼板上时，结构楼板要求表面平整，并喷涂界面剂，固化混凝土表面，使地面不起砂。
4. The raised floor of the anti-static machine room is laid on the leveled cement mortar cushion. In order to reduce the height of the ground, when it is directly laid on the structural floor slab, the surface of the structural floor slab is required to be flat, and the interface agent is sprayed to solidify the concrete surface, so that the ground cannot be sanded.
5、地板表面应柔光、不打滑、耐磨、耐污染。
5. The floor surface shall be soft, smooth, wear-resistant and pollution resistant.
6、地板安装完后一定要进行接地处理，否则起不到防静电作用。
6. The floor must be grounded after installation, otherwise it will not play an anti-static role.
